Filling Colour Ink Cartridge?
Answer:
bci 24 colour:
pry bad the top, and tape the bottom hermetic.
drill into the depressions in the top. one is for wan (with the sticker facing you, i believe yellow is the departed - you will want to double check by pulling out whatever ink is vanished with the syringe). the other one on that article is magenta.
the bottom hole will be cyan (it's the one by its lonesome).
you could fill from the bottom, but it requires much more coordination, and still requires those depressions to be drilled out.
you should put NO MORE THAN 5ml of respectively colour into the corresponding holes.
make sure not to overfill. other pull a moment or two ink back out.
luck!
You can imbue each of the cartridges somewhat by dropping 50 to 75 drops (from your syringe) on to the PADS.
This will last you week or so. I refill mine every week for about a year that process. (black on the black pad, cyan, washed out and magenta on each of their pad.
However if you turn the cartridge upside down so that the wipe is on the bottom, you will see a small circle at one end which you can drill a hole ( I use a appendage drill with a 2 mm drill, simply big enough to allow the entrance of the syringe nozzle.
Now you can fill respectively cartridge near 9 ml of ink (that is manufacturers standard fill)
Now you will own to have handy a cement gun and when you have packed the cartridge you purely put a seal of hot plastic over the hole. It have to be removed each time you permeate the cartridge.
If, for some awful source you got the wrong color next your pictures will not show the colors they should. so be careful to grasp each of the colors surrounded by your hand beforehand you begin to teem.
Related Questions: