My printer ink level are incorrect?
Answer:
Perform a Factory Reset and a Cartridge RESEAT to reset theink counters and see it to put ink on the paper. Make sure the ink cartridges are installed within the printer.
1) Shut printer off. Disconnect parallel printer cable at backside of printer.
2) Hold down the all three buttons (Load button, Black Cleaning button, and Color Cleaning buttons) while powering on the printer (continue holding for approx. (1) one second and release).
3) Then inside one second
4) Hold down the Load/Eject button for (2) two seconds simply.
5) Release Load/Eject; the complete sequence must be done within (3) three second.
NOTE: A FACTORY RESET WILL RESET BOTH INK COUNTERS AND THE OTHER INK CARTRIDGE MAY NOT REGISTER OUT OF INK WHEN OUT OF INK, THE OUT OF INK LIGHT MAY NOT FLASH OR TURN ON.
There is no other way to correct your situation so you will inevitability to monitor the other ink level and amend it if poor color quality cannot be corrected by cleaning cycles.
RESET:
1) Pause the printer, hold down the Load/Eject button for 6 second; power light will blink.
2) The print boss will move to left to videotape installation position.
3) Lift the Gray Clamp that holds the ink cartridge adjectives the way overt then clamp it stern down
*** MAKE SURE YOU DO NOT TAKE INK CARTRIDGE OUT ***
4) Once the clamp is closed, press and release the Load/Eject button to recharge the Ink Delivery system (takes about 2 minutes).
you better cal a service man and try to solve the problem ... or cal to the customer supervision ..
Its always approximate .. not sharp ........!!!!
What exactly you looking for..?
Which model printer you are using...?
shake the catridge later replace them in the printer, after will indicate the correct level
Related Questions: