Inkjet printer?
Answer:
If you are using a finisher/sealer on your ink squirt prints you have to be extraordinarily patient. Start beside multiple coats, the first coat should be very pallid and hold the nozzle of the spray can a good 12 to 15 inches away from the daily and spray in short and small amounts, delicately as possible. Try spraying across the print instead of directly down on print. Spray cans tend to own finer spray when you hold them vertical and less arbitrary of drips forming. Make sure your fingers are not in the process of the spray coming out, where the product can accumulate and form drops.
Once the first coat is dry according to manufacturers instruction on can, you can do a second coat following indistinguishable rules very street light and far away from print.
It is the moisture in the finishing spray that do runs, fish eyes and ink bleeds to happen. The smallest amount of moisture the better.
Finishing sprays can be used but you have to obtain the technique down pat. I have used finishing sprays on inkjet prints for years immediately.
Maybe you can try a different kind of dissertation. Maybe decoupage glue would be useful.
Use a different paper ?
If you're using conventional paper consequently I'm stumped, but with any other concerned of paper, it may be the finish.
Buy a unsullied HP inkjet printer like the C5180. Photos are rainproof.
The HP C5180 does some of the best photos I've ever seen come out of an inkjet. Much better than what you take at Wal Mart. It also copies, scans, and prints.
Laminating would work for sure. But try Acrylic Laquer from a sports car accesory shop.
Related Questions: