Have a Packard Bell flat blind fonts are blurry?
Answer:
Packard Bell? How older is this monitor?
I'm going to assume you have an dated CRT flat screen monitor, not an LCD. If this is the satchel, it's time for a new monitor - as it ages, a CRT deteriorates surrounded by several ways - the phosphors wear out and brightness fades, components lower and focusing starts to fail - it sounds close to you just entail a new one.
If within fact you own an LCD monitor, there are a couple possibilities - maybe you are set to a lower screen resolution than the monitor is designed for - some LCD's are better than others at displaying lower resolutions than they are designed for, but adjectives are blurry to an extent if used at anything less than full resolution. A immediate guide (these are general, at hand are exceptions) - 15" lcd generally should be set for 1024x768. 17" 1280x1024. 19" and above 1600x1200. Like I said though in that are exceptions - find the specs for your monitor to be sure.
Another possible problem with an LCD is an analog sync problem. Make sure your video card is set to liven up at 60Hz. Some can handle 75Hz, but within is no benefit to doing this on a flat panel, so resetting to 60Hz may help. If your Monitor and video card both own a DVI port, that would most certainly solve your problem as nearby would be no need to sync next to an Analog signal.
Hope this helps!
Try increasing the resolution on the other PC by going to the Display tool surrounded by the Control Panel. Click on the Settings tab and try sliding the Screen Resolution setting one setting higher.
Related Questions: