The hinge on my laptop are broken what could I use to replce them?
it to astay at 90 dgrees.
Answer:
OK-this won't be pretty but it'll work.
First, you will enjoy to go to the hardware store. You will call for what are known as L-brackets. (2 of them) I would voice to get them almost 4 inches-you may have to approximate this, but if you enjoy to, longer is better.
You will also need a hacksaw- you are going to be shortening one leg of the "L" bracket.
You will entail what is called "emery paper" or "emery cloth". It is approaching sandpaper, but is used for metal-the hardware guy will know what it is.
You will need epoxy glue-they in actual fact have it surrounded by "syringes" that make it graceful to mix equal parts of the epoxy.
What you are going to do is shorten one leg of the "L", and glue the long leg to the posterior of the laptop in such a mode that the short leg will support the laptop lid when it is open. Lay the bracket on the table beside the short leg up. Next, set the laptop on top of the brackets near the lid open and supported by the short legs. Mark the bracket beside a felt tip pen at the EDGE of the bottom partially of the laptop. This will guide you when you glue it down. Next, close the laptop and turn it over. You will have need of to find space on the bottom to glue these brackets lacking covering something important, such as the freestyle compartment. Take your L brackets, which you have tarnished, continue the flaw around to the other side of the bracket (so that you can see the mark everything way it faces). Now, turn the laptop over so that it is bottom side up, and place the hinge perimeter at the edge of the table. Take your L brackets and place them contained by position, with the short leg presently pointing DOWN, and your mark at the threshold of the laptop. Make sure you are not covering something vital on the bottom of the laptop. Then, mix your epoxy epoxy resin according to directions, and glue your L brackets into place. You will hold to work fairly hurriedly, since the epoxy will begin to set within under 3 minutes. Once you hold them glued into place, set something on top resembling waxed tabloid or aluminum foil, and something fairly immense like a textbook resting on that. Let it cure according to the directions on the epoxy (probably 12-24 hours). Then, you will be able to begin the laptop and the lid will rest on the short legs of the "L" brackets. I do have a jpeg sketch I drew using MS Paint that might aid you visualize it- just e-mail me so I carry your return address and I will send it to you.
Related Questions: