A cross-examine in the order of concrete drives and errors..?
Answer:
That drive is SATA. You don't own to concern yourself with master/slave jersey settings.
You will probably need a floppy disk beside the SATA controller drivers on that you use during the XP install process (hit F6 when it asks).
Check in your BIOS as all right to make sure that you havent enabled RAID when it isn't needed, or that class of thing.
Best of luck
Paul B.
The controller.
Swap the disc drive and the disk drives over between IDE1 and IDE2 connectors to see if it's the motherboard.
There should be a jumper position diagram resting on the hard drive. Normally to set your drive to a master the pullover should be on the left appendage pins - but check the diagram.
If you have manage to boot your PC then you do not hold a jumper problem. You cannot boot a PC if the easier said than done drive is set to slave.
There are various diagnostic test available to verify your hard drives read/write experience. Seagate has a pious diagnostics program. Check their site for details.
Could even be a memory (RAM) error. Sometimes this causes the sort of corruption you are mentioning. Have you get a diags utility for your motherboard? You may be able to download one from the manufacturer's website. This would see you to thoroughly check all of your attached hardware.
The merely `hard drive` I have understanding of is my missus!
Related Questions: