ATA and SATA Hard Drives In One System?

Hey. I'm trying to do something and I don't know if it's possible or not, but I bought a hot hard drive [SATA] and realize I have an elder computer that only have IDE/ATA connectors. I bought an IDE-SATA adapter, but I guess that means I won't be capable of have both complex drives hooked up at once, right? The older strong drive is an ATA-- is there any passageway to have both complex drives hooked up using the adapter? Or will I have to choose between the two?

Thanks!

Answer:
If it is a IDE to SATA adapter afterwards it should make the SATA drive look similar to a IDE drive.

You are allowed 2 IDE drives per channel, one must enjoy the jumpers set to master the other set to slave.

Typically nearby are 2 IDE channels on the motherboard.

If you can not select master/slave on the adapter, afterwards you could put the current hard wallet as master on channel 0 near the optical drive as slave, and then put your SATA drive+adapter on waterway 1. Unless you have two optical drives.

You could other take the adapter put money on and get a SATA controller board. That would allow you hold advantage of any extra speed from the SATA drive over the IDE bus and to make a payment more SATA drives in the adjectives.

i have a computer that have both ata and sata in it look within your bios settings and see if there is an selection avalable for you

You need a ATA cable near 3 connectors (one for the MB and two for two HDs).

Your adapter should connect directly to your SATA drive and from there to the PATA cable.

There should be no problem near having a SATA and PATA drive on alike cable. If you look at the SATA spec, it actually uses indistinguishable protocol as the PATA with some modification.

This also depends on your adapter though. I do not know which one you hold, but if it is suppose to directly connect to the MB you might be out of luck.

MOST MBs have more that one PATA connector on the MB. Usually it is referred to as IDE0, IDE1, etc. They can usually support two devices respectively with most MB coming near two IDE channels.

upgrade your motherboard to one that have SATA and IDE if you have a socket 775 CPU this is smooth to do and is about as cheap an addition SATA card. If you have an elder intel or AMD based piece of equipment it might bo the time to upgrade to either socket 775 (intel) or socket AM2 (AMD) CPU. Right in a minute Intel would be the way to shift.

You can get a motherboard near SATA onboard here:

http://www.gamegiants.net/advanced_searc...

QAPOP.com

ATA and SATA Hard Drives In One System?

Topic