Switching out Dell CPU's?
Answer:
I consider you need to tuning the motherboard in your computer to bring a higher CPU.
A motherboard that fits you cant at Dell.
no, differnet motherboard. the elder one cant handle the foreign speed. it will only say aloud 1.5 no matter what.
typically the "big companies" want you to purchase a trial PC ... to answer your question it is possible that it will work...but not possible. they limit upgrade to the subsequent speed for the most part
the problem is Dell won't go away you much room for upgrade to try and force you to buy from them again, oh and if you wan't to change your motherboard, erm okay if you buy one, it won't fit in your dell suitcase, that is planned to make it tricky to upgrade so that they can try and squeeze you but all the big companies are like really, what your best off doing is proverb **** to dell and get a computer from a small business they are normally reasonalbe and they also use all standard parts so you are more free to upgrade.
That is easier done w/ retail motherboards because they usually support a wide-ranging range of processor models and speed. Proprietary motherboards tend to restrict your upgrade options because the OEMs really prefer that you buy a hot one rather than upgrade.
But you could donate it a try and tell us subsequent how your luck played out.
Yes the GX260 processor (P-4 socket 478, 2.4Ghz, 533fsb) will physically fit. The motherboard will even automatically recognise it. A GX240 & GX260 are almost identical. A GX240 uses a P-4 socket 478, 1.5Ghz, 533fsb processor. You should even know how to use the heatsink and fan from the GX260 within it. Actually, there be several different speeds available on the GX240 boards from Dell. From the lowest 1.5Ghz, to the 2.6Ghz They all use impossible to tell apart motherboard, but just come with a different cpu.
When removing the processor, maintain in mind the following:
1: Remove the green clips, consequently gently release one side of the heatsink from the tab holding it. There is one contained by the center of each side where on earth the clips were.
2: The processor will be stuck to the bottom of the heatsink, don't verbs or bend the heatsink when you are removing it or you'll damage the pins.
3: use a butter wound to gently pry the processor from the heatsink. It will usualy pop loose pretty effortlessly.
4: Do not touch the pins! They are very smoothly bent.
5: Release the locking lever and gently insert the processor into the holder on the board. It will just fit one way, and should drop within with nought force. Do not push it in, or you'll bend the pins.
6: lock the processor surrounded by place by placing the lever in the down position.
7: Use an alcohol wipe, and verbs off adjectives the old heatsink compound from the heatsink and the processor.
8: Apply a small wipe (About the size of a Tylenol Gelcap) of Silicone Heatsink compound (Available at Radio Shack or computer stores) to the center of the processor back.
9: re-install the heatsink, and trade name sure that it fully seats contained by the holder. It should click into place with a bit pressure.
10: Reinstall the fan, and receive double sure it is plugged into the motherboard. <Yeah, I've forgotten before...
11: Close the casing and boot the PC
12: At boot, press F2 several times until you see "Entering Setup mode"
13: In setup, verify the processor speed detected, and the close. Saving any changes and reboot.
14: Enjoy!
Personally, I detest Dell. And I would suggest building your own computer. You could build a fast investigational one for about $565.00 if you draw from the parts from http://www.tigerdirect.com But if you don't need a tentative monitor, it would be $415.00
More Questions and Answers ...
Related Questions: