Can I Use Any Hard Drive In My Pc?
Answer:
No, you can't use any drive. You necessitate one that is supported by your motherboard. Most systems support IDE drives.
ask best buy or circuit city later will no good luck
You will stipulation to install a "fresh" operating system on the new HDD and find adjectives the device drivers.
yes you can use any hard drive contained by any pc.
Yes you can. Just reformat it to your contemporary PCs file system. Your PC already have drivers for fixed disks.
You can fit any standard format IDE drive in your piece of equipment regardless of make.
Just craft sure you put the jumpers within the right positions. If you are adding it to your current electrical device make sure it is set as slave connected to another drive set as master.
If you are replacing the existing drive, set it as master. You will want drivers for the rest of your devices on the Packard Bell
No drivers are needed for hard drives.
yes you can make a payment your old rugged drive as slave after you change the pullover
and you don't need any driver the computer will pick it up .
Make sure your trial hard drive stay as primary master ,the outmoded one as
slave ,you can not boot from it but you access all the information in the ripened hard
drive.
There are single two types SATA & IDE, you probobly have IDEand yes as long as it have the proper connection (IDE or SATA) you can use any rock-hard drive no drivers needed !
No, you can't use any drive.
You need one to be precise supported by your motherboard
If you mean attach it as a second drive (slave) to your existing drive (master) - then yes. Your will have need of a two socket 40 pin IDE ribbon cable and need to remove the jumper from the old drive.
Yes you can, so long as you can fit ity contained by your case and hold enough appropriate cable (IDE or SATA).
Remove the old drive, check the jersey configuration on the back (little bit of plastic that sits on the pins at teh vertebrae, to set the old drive to slave. Install it into your skin and plug it in to your M/B. Connect teh drive to the power supply by using a spare Molex (4-pin) connector.
Start the PC into it's BIOS eyeshade (usually done by pressing "delete" during the boot-up sequence), go into the appropriate menu on BIOS, engender sure the drive is recognised (It will show as Primary Slave or Secondary Master, depending on how it's connected).
Svae your BIOS changes and reboot. Go into Windows as per usual, right click on "My Computer", select "Manage", shift into the disk manglement part, format the freshly installed "slave" drive to your preferred directory type (NTFS or FAT32).
Bob's yer uncle. Easy. Computers are far more straightforward than the mugs at PC World will have you believe!
Related Questions: