I bought and installed the ECS p965t-a motherboard and can't bring back more than one HD to work. Why?

This is my first post here and I hope someone can lend a hand me. I bought and installed the p965t-a and got the computer to power up and even to the point where on earth it starts loading the OS on the hard drive. But I can't attain more than one IDE device to work at the same time, and the BIOS doesn't sanction anything as IDE master or slave. It finds the hard drive, but solely in the "boot sequence" menus of the BIOS (and in attendance, oddly, as SCSI). I'd approaching to have a thorny drive work and also my CD-ROM drive so that I can install an operating system (since my old one be spread out over several HDs). Can anyone help me? Sorry for man inept.

Stephan

Answer:
As people enjoy said, check the jumper settings of adjectives your devices. On each IDE drain (cable) there will be a connector partly way up the cable and another one right at the thoroughly end of the cable. Whatever device is at the back of the cable should be set to Master, and any device half passageway up should be Slave.

And if you don't know what I mean almost jumpers later this is the kind of entity you're looking for:

http://www.hiroinc.com/harddrive/hd2.jpg...

The jumper is somewhat plastic tab that sits over one of the pairs of pins on any hard drive or CD/DVD drive. There should be a diagram on the put a bet on of the drive showing you which pins need to be covered for respectively setting (master, slave or sometimes 'cable select).

did u check the jumper settings on the HDDs

Sounds close to you didnt set the jumpers on the devices properly!

boot sequence should be cdrom afterwards HD0 .... the main bios page should show drives .. look for other bios settings for settle and make sure ur timings are correct ...try loading bios default if nothing else ... its somthing contained by ur bios settup or cabling ...

I enjoy and ECS board but not the same one as yours. check your bios in that is a setting for the ide slots where on earth you can enable 1 or both of them.

I notice on the ECS website that there is an IDE driver available. Did you nouns them from your motherboards startup disk?

Here is the website where can download adjectives the drivers and manuals and bios updates for your board.

http://www.ecs.com.tw/ecsweb/products/pr...

QAPOP.com

I bought and installed the ECS p965t-a motherboard and can't bring back more than one HD to work. Why?

Topic