Computer error messages?
I enjoy tried the jumper settings but doesn't work.
Answer:
The "ntldr missing" is the error message that you take when trying to boot from a disk that doesn't have the ntfs record system on it. If your BIOS has an alternative to set the First Boot Device, change it to your SATA drive. If you can find into Windows, just right-click on the drive, and select Format. You'll later be able to use it as you typically would, for storing files on.
If you aren't able to take into Windows, download this: http://www.ultimatebootcd.com/download.h... Or, you could use your Windows cd, if you have Windows XP, but the steps are a touch more complex.
Perhaps your machines is trying to boot to the 40GB drive instead of the 80GB drive? Thats the only article I can think of at the moment. When contained by doubt, you can always try to do a repair beside the windows cd.
Ok did some research and here is your possible solutions.
1. Format your second intricate drive.
2. Boot from Windows XP by restarting and making sure it say "Press any knob to boot from cd rom".
Go to the Utility that is surrounded by recovery. Type within "fixboot" and push in the correct command for d: (your second frozen drive).
Is the 40GB a "master" or a "Slave"? If it is a master, the system will try to boot it. The drive may be jumpered for "cable select", in which crust it determines the M/S status from it's position on the cable. Far end of cable = master, farther surrounded by = slave.
More info:
http://www.computerhope.com/issues/ch000...
Hi there;
Did you remember to sort a master/slave designation in your BIOS?
Or.... you may enjoy to make some adjustment to your OS. Microsoft does have a work around for this problem.
I would recommend that you follow the MS route if your dated drive was running on a contrivance older than the one you are presently using. :) good luck
PS. check out the work around at microsoft.
reformat the second HD using the cd of your OS., later you need to take home a parition., make you r 80gb HD as ther master by putting the jersey in the first two pins(if your HD is seagate but but for try to look at the configuration at the manual) then remove the jumper on the second HD...
First of all the prevalent Hard Disk U hav the OS should be Cable selected. Then the inferior hard disk U r trying append,in that remove any jumper if there are any. Refer the picture on the tricky disk and for the Cable Select help for the largest hard disk ( Since for some disks if U are totalling a secondary Hrd disk U hav a seperate type of Cable Select). Removed any invalid boot medium in Ur disc Drive and floppy drive.
there is with the sole purpose one answer to this problem and it is that you did not designate the 40 GB HD to be the slave so the computer is thinking it is the master and looking for the boot data on that HD when the facts resides on the 80 GB HD. But to tell you how to fix it i would enjoy to know what brand of HD they both are. But you CANNOT i repeat CANNOT fix this problem by fixing the software.
This problem may occur if the essential input/output system (BIOS) on your computer is outdated, or if one or more of the following Windows boot files are missing or damaged:
Ntldr
Ntdetect.com
Boot.ini
To resolve this issue, verify that the BIOS on your computer is current, and next use one or more of the following methods, as appropriate to your situation, to repair the Windows 2000 startup environment.
Related Questions: