Which portion of the CPU can you put your hot DVD/CD combo drive contained by?
Answer:
In your computer, in that are expansion drive bays located at the bottom of your existing ones. This is guarnteed to be in attendance, because all computers own at least 1-4 expansion bay. My computer has 4 expansion bay, and I do not even use them!! : ) Anyway, here is how to install your Hard Drive:
1. *Make sure your computer is off*
2. Take the cable supplied with the Hard Drive, connect it to the pins on the Drive, next connect the other end to a portion on the motherboard.
3. Snap the drive in place, but trademark sure to not break the case, or the Drive.
4. start your computer up
5. step into the BIOS system, or the setup menu
6. go into the quantity where it say hardware, and activate your Hard Drive contained by the device channle that you installed it in
7. Your computer will plug-in-play the Hard Drive, and it will be prepared ro use
There should be free drive bays any above or below your existing CD/DVD drive. If there aren't, you'll necessitate to replace the existing drive with the bright one. You'll need to remove the cover from any existing unused drive creek before you can install the drive.
Two things want to be pointed out: There is a master and a slave on the connection. If you are installing 2 optical drives, the first is slave (in the middle of the cable ribbon}and the 1 on the finale is master. This is selected by looking on the bottom of the drive in the vicinity the back and find which pins will be jumpered.If the present 1 is cable select, gross them both cs. If it is master make the hot one slave and install it in the middle of the ribbon. Go to the bios at boot and see both optical drives. The computer should then sanction the drive.
Related Questions: