Back of my computer is a red switch for 110 or 230w power supply.Does this be set to it is adept of 250w?
This is a followup quiz.
The video card I want to buy requires 250w.
So I want to know if the 230w specified on the outlet-located on the back of the overnight case means I can turn it on to 230w.
Would that be satisfactory wattage because the card says 250w.
Sorry guys,I am awfully computer illiterate.
Answer:
Look again very with care. The choices are most likely 110 and 220 and these probably refer to the incoming voltage from the wall to the power supply. I don't chew over that this will change the wattage that your PS will pedal, but be careful.
That switch is for using the computer contained by countries overseas which have that power. Don't switch yours, In answer to your unproved question almost your power supply, Most newer computers come with at tiniest a 250 watt power supply. But to be sure without introductory up the box just beckon the manufacturer and ask them the specs.
first past its sell-by date, are u sure about the recommendation on the video card u purchased. to answer your question, the red switch routine you will be able to use your computer contained by areas that put out 220w of electricity. i am not sure if it will work over the recommended watts. also, if u are living in america, the recommended electrical output is 110w-120w. so if u be to switch the red button, you will screw up your comp...
You are confusing the values. It's not 110 or 230w (watts), it's 110v or 230v (volts). The red switch is to clear your computer compatible with 230 volt power systems oversees.
There should be optional information that states the actual wattage. Most power supplies are 250 watts or greater.
The card itself does not use 250 watts, this value is the recommended pro so that the computer and video adapter combined will have adequate power.
The switch on the back is for select the input voltage from the wall. If you're in europe you would set it to 230, if you're within north america, leave it at 110. This is a reading of VOLTAGE, not WATTAGE.
You call for to look at the side of the power supply to determine it's max wattage. The max wattage is usually part of the power supply's model #. So, if you see something resembling AC-420ATX, you are very plausible looking at a 420Watt power supply.
If you are unsure, have a technician check it out otherwise you may do impair to the hardware.
110 volts is for american power, 220volts is for europe. To find out the wattage, open the computer covering and look at the sticker on the powersupply itself. It will state the wattage.
That switch is only for switching from 110Vac to 230Vac. Switching it to 230 say you are plugged into a 220Vac outlet. It has nought to do with the Wattage that ths PSU will provide.
On the power supply it will enjoy a label that states what the PSU Wattage is.
Good Luck
You are confusing the VOLTAGE input near the POWER OUTPUT. The voltage is what comes out from the outlet (110v in North America, 220-230v within Europe.
the switch will change the voltage input for the power supply on your computer. The output will not modify.
this should be listed on the rear legs of the power supply, or on a label attached to the side on it (you will have need of to look inside the computer for it. If you have a computer tower, you should hold, as a minimum, a 250 watt power supply, but it could be as high as 400 watt.
If you convert this to 220v and plug it into a 110v outlet, then you will most imagined fry the power supply and may cook the computer's other components, if the power supply can't stop the surge in time.
Related Questions: