Why my computer does not certify my unmarked HDD?
I freshly got up to date 300GB HDD and replaced it to my old one (40gb). Before I put a fresh window XP version on my unsullied HDD I had to format it and after adjectives, when windows installation be over I noticed that window show that my HDD has solitary 127GB of space.
Any suggestions? Is there any software that could correct this problem?
Answer:
Did you format beside NTFS?
If not, do the setup again, delete the partitions, create one colossal one formatted with NTFS.
Or, if someone have Partition Magic, it can do this with your current install.
your motherboard probably can't authorize newer larger HDDs
check your motherboard manual for insinuation.
If you motherboard is fairly tentative - 2years prolly, you might have more problems...
You inevitability to update you system. Go to Microsoft Update.
Use partition illusion software to re size the partition.
XP will not certify anything over 130 GB without SP2.
Note: if you enjoy Windows XP SP2 installed and Windows doesn't register the full size it's a motherboard limitation.
You call for to do one of several things.
You don't have a copy of XP beside Service Pack 2. XP with Service Pack 1 one and only formats hard drives to a maximum dimensions of 127 GB.
1. Get a copy of XP with Service Pack 2. Format and install from the XP SP2 disk.
Acquire a copy of Partition Magic 8 or a similar disk partitioning software.
Follow the instructions to create 2 floppy disks from Partition Magic.
The 2 floppy disks will allow you to hedge and format your drive to its maximum capacity.
I basically successfully partitioned and formatted a 250 Gb disk.
(my suggestion if you go near Partition Magic is to partition next to the drive as your primary, BUT DO NOT FORMAT.
Once you have PARTITIONED, start the XP install, and consent to XP format.
Good luck
There are a few things to look at. Depending on your PC's age, you might have to update your PC BIOS. You can survey the vendors net sites as in AMI.
Your mother board chip set might not endorse that size hard drive and the knotty drive. Check the web and the mother board MFG for details on drive dimensions recognized.
Finally at hand is the Hard Drive itself. Some of these hard drives come next to software that must be installed. This too will require the motherboard components and chip set to be updated to work.
If all else fail,, you can partition the rock-hard drive into three drives. After formatting the drive, set the "C" drive as 100Gig, the "D" drive as 100 Gig, and the "E" drive as 100Gig. There you now enjoy 300 gig available. Remember that your compact disc ROM devices would now purloin the next available drive note.
Related Questions: